Boxes for Tiles
Cactus Mug Wraps
Dog Shirts & Bandanas
Heat Gun mt-4
Home Decor items
Inserts for Clocks
Movements for Clocks
Pet Tees and Tags
Resin Tile Frames
Urns for Pets
Care and Usage
This guide will help assist you in getting the best possible results from imprinting your products with the VersaPrint Paper and OEM laser toners. As there are many variables involved due to the different laser printer and substrate combinations, your best results may differ slightly, but this should be used as a starting point and adjusted as needed.
ALWAYS use the multipurpose or bypass tray and select the "thick" paper option. Feed one sheet at a time to avoid paper jams and print on the glossy side of the paper for hard goods. For fabrics, print on the side with the stabalizer strip fed first into the printer. Allow ½" blank on that side to allow for the strip.
Apply using a commercial heat transfer press at 375 to 390 degrees F. (190 to 198 degrees C.) using heavy pressure. Times are as follows:
Print upside down on a Nomex Felt or similar type pad. Use 1/8" green silicone rubber pad over the tile. Press at 300 degrees to 325 degrees F. for 3 to 3 1/2 minutes. Allow to cool before removing the transfer and then post-cure in a 400 degree F. oven for 15 minutes.
In a mug press, use 300 degrees F. for 3 1/2 minutes. With Cactus Wraps, bake at 300 degrees for 15 minutes. Allow to cool before removing transfer and then post-cure at 400 degrees for 15 minutes.
Print right side up with a 1/8" green silicone rubber pad on top. Make sure paper covers the entire piece of acrylic. Press 1 minute at 350degrees, rotate 180 degrees and press for another minute. Allow to cool before removing transfer. If a white background is desired, use white sign vinyl.
A good starting point is print right side up with a plain piece of paper underneath the plastic and another over the transfer. Place a 1/16" green silicone pad on top and press at 300 degrees F for 1 to 3 minutes depending on the plastic. Cool quickly on a cool flat surface (such as a Cool Plate or something similar). Allow to cool before removing transfer and do not post cure. For sign vinyl, use a Teflon sheet underneath rather than paper.
Print face up with a 1/16" green silicone pad at 300 degrees F for 1 minute. Allow to cool before removing transfer and post cure in a 400 degree oven for 5 minutes.
Paramount Services Inc.
2205 SW 57th Avenue
Hollywood, FL 33023
(954) 981-9661 Local/International